Wheel Equipment Wheel Mold Car Mould Car Parts Axle

End diameter jump online detector

End diameter jump online detector

This equipment can realize test for radical run-out and axial run-out of wheel rim. To satisfy requirement to test tact, the clamping device, jacking device and pressing device all use pneumatic actuator, which can clamp and locate rim quickly.

Details

Summary

This equipment can realize test for radical run-out and axial run-out of wheel rim. To satisfy requirement to test tact, the clamping device, jacking device and pressing device all use pneumatic actuator, which can clamp and locate rim quickly.


The workpiece from last process of fitting-press machine to this process will be conveyed to the appointed position, workpiece will be detected by detecting switch and will be conveyed below detection position by clamping device. The jacking device will jack workpiece up, clamp it and locate. Pressing device will press the workpiece. Servo motor rotates to drive workpiece rotation. The testing device will test workpiece. After test the qualified product will be conveyed to next process by transmission device, and the unqualified one will be selected out by the selecting mechanism.


This equipment realizes automatically production process and visual testing data. It achieved target of constant production, quality improvement, consumption reduction and high efficiency and pragmatic function.

Specification

设备型号

Model Number

JCJ13-18AH

电网电压

Power Supply

AC 380V, 3phase, 50Hz

轮辋最大宽度

Rim Max. Width

290mm

轮辋最小宽度

Rim Mini. Width

120mm

压缩空气

Compressed Air Pressure

0.4~0.6Mpa

轮辋最小直径

Rim Mini. Diameter

12 inches

轮辋最大直径

Rim Max. Diameter

18 inches

中心孔定位精度

Position Accuracy of Centre Hole

0.03mm

主轴自身径跳精度

Radial Runout Accuracy of Spindle

0.03mm

Equipment Structure Introduction

This equipment can be divided into four parts: control system, feeding system, testing system and selecting system. It mainly consists of transmission device (1), clamping device (2), jacking-rotating device (3), pressing device (4), testing device (5), selecting device (6), etc., shown as below pictures.

Its automatically feeding device can be connected with production line. This equipment can convey workpiece to the appointed processing position automatically. Clamping device grips workpiece and conveys it to testing part. Jacking device locates and lifts workpiece up. Pressing device presses workpiece, jacking-rotating drives workpiece to rotate and testing device will do the online testing operation.


© 2018 Shandong Xiaoya Jinggong Machinery Co., Ltd.|Lu ICP 11005049-1


Sweep Learn more

Address:No. 51, Industrial South Road, Jinan City, Shandong Province

International Trade Department:+86 0531-83122188

E-mail:xiaoyatooling@163.com

+86 400-6586-222